Homepage
Page 69
Contact Me for More Info
Email: cougar_hs@frontiernet.net
IF YOU ARE READING THIS TO INSTALL YOUR KIT, THANK YOU FOR YOUR ORDER !!

EVERYONE , AND I MEAN EVERYONE , READ THIS FIRST!

THIS STUFF IS IMPORTANT!

1. IF THE (+) POSITIVE LEAD AND THE (-) NEGATIVE LEAD OF THE HALL SENSOR ARE HOOKED UP IN REVERSE THE HALL SENSOR WILL BE DESTROYED !!!!!

2.  IF A VOLTAGE IS APPLIED ON THE OUTPUT TERMINAL (WIRE) THE RESISTIVE ELEMENT AND
ELECTRONIC COMPONENTS MAY BE DAMAGED IN THE SENSOR !!!!

3. FOR THE EXPERIMENTERS- WHEN MEASURING VOLTAGES FROM THE SENSOR OUTPUT USE A  DIGITAL TESTER, AN ANALOG TESTER MAY DAMAGE THE RESISTIVE ELEMENT OR ELECTRONIC COMPONENTS OF THE SENSOR !!!!!

4. DO NOT CUT THE WIRES SHORTER ON THE SENSOR, HIGH TEMPERATURES WHEN SOLDERING  (300 DEGREES CENTIGRADE FOR MORE THAN 5 SECONDS) MAY CAUSE DAMAGE INSIDE THE  SENSOR, THE LONGER THE WIRE THE LESS LIKELY THIS WILL BE A PROBLEM !!!!

5. BE SURE THAT YOU USE THE CORRECT WIRING DIAGRAM . THE + HS2 MK II JOYSTICK AND THE
+ HS1 THROTTLE KIT ARE WIRED UP DIFFERENTLY. IF YOU WIRE THEM  USING THE WRONG WIRING
 DIAGRAM  THE HALL SENSOR WILL BE DESTROYED!
HOW TO INSTALL THE + HS2 MK II™ AND +HS3 MK II™ HALL SENSOR JOYSTICK KIT